
Engines & Controls
3-19
To start the engine the remote control handle must
be positioned in neutral.
Next, position the lanyard stop switch to the “run”
position. If it is in the off position the engine will
crank over in neutral but it will not start. Always
ensure the lanyard stop switch is attached to a
secure piece of clothing such as a belt. For more
information, refer to the safety lanyard section
later in this chapter.
Turn the ignition switch to the start
position. The engine starter will
crank over the engine which will
allow it to start. Note there is a 20
amp breaker located next to the
ignition switch.
The breaker protects the ignition
switch circuitry against any overload
conditions or voltage surges. Should
an overcurrent situation develop the key switch will not engage the
starter when it is in the “start” position.
DTS Remote Control- Engine Start-Up Procedure
20 Amp Breaker
Engines & Controls
3-19
To start the engine the remote control handle must
be positioned in neutral.
Next, position the lanyard stop switch to the “run”
position. If it is in the off position the engine will
crank over in neutral but it will not start. Always
ensure the lanyard stop switch is attached to a
secure piece of clothing such as a belt. For more
information, refer to the safety lanyard section
later in this chapter.
Turn the ignition switch to the start
position. The engine starter will
crank over the engine which will
allow it to start. Note there is a 20
amp breaker located next to the
ignition switch.
The breaker protects the ignition
switch circuitry against any overload
conditions or voltage surges. Should
an overcurrent situation develop the key switch will not engage the
starter when it is in the “start” position.
DTS Remote Control- Engine Start-Up Procedure
20 Amp Breaker
Commenti su questo manuale