ClimateRight CR-2550 Manuale del Proprietario Scaricare il pdf (Pagina 167)

CHAPTER 6

6-24

Keel Offset. By pressing the “ON/OFF MODE” k

eypad again displays

the “KL” keel offset setting. It can be set so the depth ﬁ nder shows

the depth below the transducer or the depth under the keel. Press the

“UP” or “DOWN” arrow keypads to adjust the reading to the desired

depth no further than 19.9 feet.

An example would be if the keel bottom is 3 feet below the transducer

and you desire the depth sounder to read the depth below the keel, the

display should be adjusted to read 3.0 FT.

Note: Once the keel offset is programmed, the shallow and deep alarms

will be energized by the depth under the keel.

Units. Pressing the “ON/OFF MODE” keypad again displays “UN”

on the LCD indicating the units mode.

Press either the up or down arrow keypads to set the units desired to

(FT) feet, (M) meters, or (F) fathoms. Once these units are set, they will

remain the same for all modes. By pressing the “ON/OFF MODE”

keypad again returns the depth ﬁ nder to normal operation.

Note: At the step area there

is an access plate. Under

the plate near the keel is the

depth sounder transducer.

It bounces a constant signal

off the bottom and sends it

to the dash head unit. Never

use bottom paint on the

hull side of the transducer

since it will effect the unit’s

operation.

Transducer